#Flysky receiver setup serial#

What else could i test?ДЇYI: I had disconnected the Motors VCC/GND and GND/Signal of the ESCs. I think its a hardware problem, but i cant figure it out exactly. Therefore i think the Nano hang-up and stop working correctly.

#Flysky receiver setup serial#

immediately the LED on the X6B receiver stop to blink and shines constant (= connection between receiver and transmitter) AND the Nano hang-up! I know it because the serial monitor stops sending pulses, instead there are the ?вё®вё®? Symbols (like when you have the wrong baud).ДЇurthermore i testet it with a constant blinking LED in a modified sketch, an the blinking also stopped when i turned on the RC. Receiver LED blinks, searching a transmitter signal. Test-Case 2: Powering the Arduino with a 3S Lipo (12.6 V) via Vin, also connected via USB to read the serial Monitor

Bind the receiver and radio (in this case we can bind the receiver by pressing the BIND. Test-Case 1: Powering the Arduino via USBД®verything works! The serial monitor shows the pulse of every channel between 10. Conect the receiver 'FS-A8S' to FC (Those steps are identical like the manual) Connect black cable to pin G of FC. If (millis() - t DETECTION_SPACE) || (i > CHANNEL_AMOUNT)) auchДЄttachInterrupt(digitalPinToInterrupt(RECEIVE_PIN), ppm_interrupt, METHOD) So it should work (see Test-Case 1) #define RECEIVE_PIN 2 // Pin 2 geht z.B. Sketch I use (its only the RC part of the whole Drone Sketch): i found it on a homepage, i already flew with it several times (in another hardware build). When the Lipo is connected, the incoming voltage at the Vin is round about 11.5 V (Nano gets warm, but not much) I placed a diode, to get a voltage-drop and protect USB-Port. I want to power the whole electronics of my quadcopter with a 3S Lipo (12.6 V) via Vin. GND is connected to GND of Nano and VCC to the 5v of Nano. The X6B is connected via PPM-Output to the Arduino Nano Pin D2.

I use a FlySky X6B Receiver for receiving Throttle-inputs etc. To return to default settings press and hold the 'OK' key for 3 seconds,press and hold the 'CANCLE' key to save. Press and hold 'CANCEL' to save and exit. But, if you are a beginner you might probably be overwhelmed with all the buttons, toggle switches, joysticks. IвЂ™m struggling with a strange behaviour in my drone project and need some help. To return to default settings press and hold the 'OK' key for 3 seconds,press and hold the 'CANCLE' key to save. The FLYSKY FS-i6 transmitter and receiver comes with a lot of bells and whistles allowing you to fully customize your flight setting and use it from basic drones, airplanes, helicopters to complicated multi copters and racing drones.